Submit Manuscript  

Article Details


Design of 0.28-V 260-uW CMOS VCO Based on Quasi Current-reused Topology Using Transformer Feedback and Body Biasing Technique

[ Vol. 11 , Issue. 4 ]

Author(s):

Wei-Jhih Li*, Meng-Ting Hsu and Li-De Huang   Pages 379 - 386 ( 8 )

Abstract:


Background: Design of an ultra-low voltage 0.28V CMOS VCO based on current reused topology for low power application is presented. The high performance of ultra-low voltage operation is achieved by way of the transformer feedback and body bias technique.

Methods: The total power dissipation can be achieved as low as 260µW, while VDD1 and VDD2 are both 0.28V. The swing of output signal above the VDD supply voltage is improved by transformer feedback loop. The tuning range of proposed VCO is from 2 to 2.3 GHz under 0.28V supply voltage which PMOS and NMOS transistor with the threshold voltage is around 0.52V and -0.52V, respectively.

Result: The measurement of phase noise is -106.5dBc/Hz at 1MHz offset from the 2.26GHz frequency carrier at 0.28V.

Conclusion: The chip is implemented with 0.18μm CMOS process and its figure of merit is - 179.4dBc/Hz.

Keywords:

Low voltage, low power, Voltage Controlled Oscillator (VCO), phase noise, transformer, body bias, current reused topology.

Affiliation:

Department and Institute of Electronic Engineering, National Yunlin University of Science and Technology, Douliou, Yunlin 64002, Department and Institute of Electronic Engineering, National Yunlin University of Science and Technology, Douliou, Yunlin 64002, Department and Institute of Electronic Engineering, National Yunlin University of Science and Technology, Douliou, Yunlin 64002

Graphical Abstract:



Read Full-Text article